Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)


    B270995E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 10 (GND)
    UP switch is pressed
    Below 1 Ω
    6 (UP) - 10 (GND)
    UP switch is not pressed
    10 kΩ or higher
    7 (DOWN) - 10 (GND)
    DOWN switch is pressed
    Below 1 Ω
    7 (DOWN) - 10 (GND)
    DOWN switch is not pressed
    10 kΩ or higher
    8 (OPN) - 10 (GND)
    OPEN switch is pressed
    Below 1 Ω
    8 (OPN) - 10 (GND)
    OPEN switch is not pressed
    10 kΩ or higher
    9 (CLS) - 10 (GND)
    CLOSE switch is pressed
    Below 1 Ω
    9 (CLS) - 10 (GND)
    CLOSE switch is not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Sliding Roof Switch (Roof Console Box Assembly))
    If the result is not as specified, replace the sliding roof switch (roof console box assembly).