Home › Engine / Hybrid System ยท 2AR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A194756
  1. Remove the nut and disconnect the lead wire from the magnet starter switch assembly.



    A194757
  1. Remove the 2 nuts holding the magnet starter switch to the repair service starter kit.

  1. Remove the magnet starter switch.



2. REMOVE STARTER YOKE ASSEMBLY


    A194758
  1. Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.



    A194759
  1. Remove the starter yoke assembly from the starter commutator end frame assembly.



3. REMOVE STARTER ARMATURE PLATE


    A194760
  1. Remove the starter armature plate from the starter yoke.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A194761
  1. Using a screwdriver, pry out the starter commutator end frame cover to remove it.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A194762E04
  1. Using snap ring pliers, remove the snap ring and washer.
    Text in Illustration 
    *1
    Snap Ring Pliers

  1. Remove the starter armature assembly from the starter commutator end frame cover.

    NOTICE:
    Do not drop the starter armature.



6. REMOVE RUBBER SEAL


    A194763
  1. Remove the rubber seal from the repair service starter kit.



7. REMOVE PLANETARY GEAR


    A194764
  1. Remove the 3 planetary gears from the repair service starter kit.