Home › Engine / Hybrid System ยท 1AZ-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A079718
  1. Remove the nut and disconnect the lead wire from the magnet switch.



    A079719
  1. While holding the magnet switch, remove the 2 screws from the repair service starter kit.

  1. Remove the magnet switch.

  1. Remove the return spring and plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720
  1. Remove the 2 through-bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.



    A079721
  1. Remove the starter yoke assembly from the starter commutator end frame assembly.



3. REMOVE STARTER ARMATURE PLATE


    A079722
  1. Remove the starter armature plate from the starter yoke assembly.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A288945
  1. Using a screwdriver with its tip wrapped in protective tape, pry out the starter commutator end frame cover from the starter commutator end frame assembly.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E09
  1. Using snap ring pliers, remove the snap ring and washer.

    NOTICE:
    Do not drop the starter armature assembly.

    Text in Illustration 
    *1
    Snap Ring Pliers

  1. Remove the starter armature assembly from the starter commutator end frame assembly.



6. REMOVE PLANETARY GEAR


    A081167
  1. Remove the 3 planetary gears from the repair service starter kit.