STARTER > REASSEMBLY |
| 1. INSTALL PLANETARY GEAR |
![]() |
Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.
![]() | High-temperature grease |
Install the 3 planetary gears to the repair service starter kit.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Apply high-temperature grease to the armature shaft.
![]() | High-temperature grease |
![]() |
Apply high-temperature grease to the washer and bearing as shown in the illustration.
![]() | High-temperature grease |
Install the starter armature assembly to the starter commutator end frame assembly.
![]() |
Using snap ring pliers, install the washer and a new snap ring.
| *1 | Snap Ring Pliers |
![]() |
Using a vernier caliper, measure the length of the snap ring.
| *a | Length |
| 3. INSTALL STARTER COMMUTATOR END FRAME COVER |
![]() |
Install the starter commutator end frame cover to the starter commutator end frame assembly.
| 4. INSTALL STARTER ARMATURE PLATE |
![]() |
Insert the starter armature plate to the starter yoke assembly.
| *a | Keyway |
| *b | Key |
Align the keyway of the starter armature plate with the key inside the starter yoke assembly, and install the starter armature plate.
| 5. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the rubber of the starter commutator end frame assembly with the cutout of the starter yoke assembly.
| *a | Cutout |
| *b | Rubber |
Install the starter yoke assembly to the starter commutator end frame assembly.
![]() |
Align the protrusion of the starter yoke assembly with the cutout of the repair service starter kit.
| *a | Cutout |
| *b | Protrusion |
![]() |
Install the starter yoke assembly with the 2 through-bolts.
| 6. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Apply high-temperature grease to the plunger.
| *a | Hook |
![]() | High-temperature grease |
Hang the hook of the plunger on the drive lever.
![]() |
Apply high-temperature grease to the return spring.
![]() | High-temperature grease |
Install the plunger and return spring to the repair service starter kit.
Install the magnet switch.
![]() |
While holding the magnet switch, install the 2 screws to the repair service starter kit.
![]() |
Connect the lead wire to the magnet switch with the nut.