TRANSMISSION CONTROL CABLE > INSTALLATION |
| 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
Pass the transmission control cable assembly from the cabin to the engine compartment.
Install the transmission control cable assembly with the 2 bolts.
Install the dash panel insulator to the original position.
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Connect the wire harness clamp.
Engage the 2 claws to connect the transmission control cable assembly.
![]() |
Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
| *1 | Slider |
| *2 | Lock Piece |
| *a | Slide |
| *b | Pull |
![]() |
Install the transmission control cable end to the lower shift lever assembly.
| *1 | Lock Piece |
Push the lock piece into the adjuster case.
| 2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Install the No. 1 parking brake cable assembly with the bolt and nut.
Install the floor carpet to the original position.
| 3. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY |
Temporarily install the accelerator pedal sensor assembly with the 2 bolts.
![]() |
Tighten the 2 bolts in the order shown in the illustration.
Connect the accelerator pedal sensor assembly connector.
| 4. INSTALL AIRBAG SENSOR ASSEMBLY |
| 5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
Install the air cleaner case sub-assembly with the 3 bolts.
Connect the wire harness clamp.
| 6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
Install the air cleaner filter element to the air cleaner case sub-assembly.
![]() |
Connect the air cleaner cap sub-assembly to the throttle with motor body assembly and release the lock of the air cleaner hose clamp.
| *1 | Air Cleaner Hose Clamp |
Connect the ventilation hose to the cylinder head cover.
Install the air cleaner cap sub-assembly and tighten the 2 bolts.
Connect the wire harness clamp.
Connect the mass air flow meter connector.
Connect the purge line hose to the 2 clamps.
Connect the 2 vacuum switching valve vacuum hoses.
Connect the vacuum switching valve connector.
| 7. INSTALL INLET AIR CLEANER ASSEMBLY |
Install the inlet air cleaner assembly with the 2 bolts.
| 8. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.
| 9. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Install the No. 1 engine cover sub-assembly with the 2 nuts.
| 10. INSPECT SHIFT LEVER POSITION |
When the shift lever is moved from P to R with the ignition switch ON and brake pedal depressed, make sure that the shift lever moves smoothly and correctly into the position.
Start the engine and make sure that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.