Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Remove the 2 nuts and No. 1 engine cover sub-assembly.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



3. REMOVE INLET AIR CLEANER ASSEMBLY


    A264362
  1. Remove the 2 bolts and inlet air cleaner assembly.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A264433
  1. Disconnect the vacuum switching valve connector.

  1. Disconnect the 2 vacuum switching valve vacuum hoses.

  1. Disconnect the purge line hose from the 2 clamps.

  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Loosen the 2 bolts and separate the air cleaner cap sub-assembly.



    A264435
  1. Disconnect the ventilation hose from the cylinder head cover sub-assembly.



    A264436E01
  1. Lock the air cleaner hose clamp as shown in the illustration, and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.
    Text in Illustration 
    *1
    Air Cleaner Hose Clamp

  1. Remove the air cleaner filter element from the air cleaner case sub-assembly.



5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A264522
  1. Disconnect the wire harness clamp.

  1. Remove the 3 bolts and air cleaner case sub-assembly.



6. REMOVE AIRBAG SENSOR ASSEMBLY
(Click here)


7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
  1. Avoid physical shock to the accelerator pedal sensor assembly.
  2. Do not disassemble the accelerator pedal sensor assembly.



    A275557
  1. Disconnect the accelerator pedal sensor assembly connector.

  1. Remove the 2 bolts and accelerator pedal sensor assembly.



8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Turn back the floor carpet.



    C240462
  1. Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.



9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C239451
  1. Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

  1. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.



    C239655
  1. Disconnect the wire harness clamp.



    C239668
  1. Remove the nut and clip, and disconnect the transmission control cable assembly.



    C240463
  1. Turn back the dash panel insulator.

  1. Remove the 2 bolts and pull out the transmission control cable assembly from the body.