DTC P0575 Cruise Control Input Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0575 | When both of the following conditions are met:
| ECM |
| 1.CHECK FOR DTCs |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Clear the DTCs (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control switch (ON-OFF button).
Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
Check the DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for 2AR-FE) | B |
| DTC is output (for 2GR-FE) | C |
|
| ||||
|
| ||||
| A | ||
| ||