Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0575    Cruise Control Input Circuit

for Preparation Click here


DESCRIPTION

This DTC indicates an abnormality in the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P0575
When both of the following conditions are met:
  1. STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 sec. or more
  2. 0.4 sec. have passed after cruise cancel input signal (STP input) is input to the ECM
ECM

HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function remains on until the ignition switch is turned off.


INSPECTION PROCEDURE

1.CHECK FOR DTCs
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control operation is possible.

    2. Turn the cruise control system on using the cruise control switch (ON-OFF button).

    3. Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.

  1. Check the DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 2AR-FE)
    B
    DTC is output (for 2GR-FE)
    C
    DTC is output (for 1AZ-FE)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)