Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM (for 2GR-FE)

FRONT LOWER SUSPENSION ARM (for 2GR-FE) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
  1. Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.



    C167143E01
  1. Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.

    Torque:
    Bolt 1, 2:
    200 N*m{ 2039 kgf*cm , 148 ft.*lbf }
    Bolt 3:
    135 N*m{ 1377 kgf*cm , 100 ft.*lbf }

    NOTICE:
    While keeping the nut from rotating, tighten the bolt.



2. INSTALL ENGINE MOUNTING INSULATOR
  1. Temporarily install the engine mounting insulator LH with the 3 bolts.

    HINT:
    Perform this procedure only when replacement of the engine mounting insulator LH is necessary.



3. INSTALL FRONT FRAME ASSEMBLY