Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT

FRONT LOWER BALL JOINT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
  1. Secure the front axle assembly in a vise using aluminum plates.

    NOTICE:
    When using a vise, do not overtighten it.

  1. Install the front lower ball joint assembly to the front axle assembly with a new nut.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

    NOTICE:
    Prevent oil from adhering to the threaded and tapered parts.

  1. Install a new cotter pin.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



2. INSTALL FRONT AXLE ASSEMBLY