Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Luggage Compartment Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the luggage compartment door lock assembly using this circuit.

WIRING DIAGRAM


E227473E03


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Luggage Courtesy SW
    Luggage compartment door courtesy switch signal/ON or OFF
    ON: Luggage compartment door open
    OFF: Luggage compartment door closed
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
  1. Remove the luggage compartment door lock assembly (Click here).

  1. Inspect the luggage compartment door lock assembly (Click here).

    OK:
    Luggage compartment door lock assembly is normal.



NG
REPLACE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
  1. Disconnect the 3C instrument panel junction block assembly connector.

  1. Disconnect the T3 luggage compartment door lock assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T3-3 (D+) - 3C-9
    Always
    Below 1 Ω
    T3-3 (D+) - Body ground
    Always
    10 kΩ or higher
    T3-2 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).

  1. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.



  1. Measure the resistance according to the value(s) in the table below.


    E173023E09


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3C-9 - MB-4 (LGCY)
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)