Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Rear Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the rear door courtesy light switch using this circuit.

WIRING DIAGRAM


E227472E02


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    RR Door Courtesy SW
    Rear door courtesy light switch RH signal/ON or OFF
    ON: Rear door RH open
    OFF: Rear door RH closed
    -
    RL Door Courtesy SW
    Rear door courtesy light switch LH signal/ON or OFF
    ON: Rear door LH open
    OFF: Rear door LH closed
    -

    OK:
    Normal conditions listed above are displayed.


    Result:

    Result
    Proceed to
    OK
    A
    Rear door courtesy light switch LH or RH does not operate
    B



B
Go to step 2
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH)
  1. Remove the rear door courtesy light switch assembly (Click here).

  1. Inspect the rear door courtesy light switch assembly (Click here).

    OK:
    Rear door courtesy light switch assembly is normal.


    Result:

    Result
    Proceed to
    OK (for Rear LH)
    A
    OK (for Rear RH)
    B
    NG
    C



B
Go to step 4

C
REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
A


3.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Disconnect the I13 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the N15 rear door courtesy light switch assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N15-1 - I13-1 (LCTY)
    Always
    Below 1 Ω
    N15-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)  

4.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Disconnect the I13 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the O16 rear door courtesy light switch assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O16-1 - I13-6 (RCTY)
    Always
    Below 1 Ω
    O16-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)