SEAT BELT WARNING SYSTEM > TERMINALS OF ECU |
| CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Disconnect the main body ECU (multiplex network body ECU) connectors.

| *A | for LHD | *B | for RHD |
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| MB-30 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| MB-31 (ALTB) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| MB-32 (IG) - Body ground | - | Ignition power supply (IG signal) | Ignition switch ON → OFF | 11 to 14 V → Below 1 V |
| MB-29 (ACC) - Body ground | - | Ignition power supply (ACC signal) | Ignition switch ACC → OFF | 11 to 14 V → Below 1 V |
| MB-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| I12-3 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| MB-18 (DBKL) - Body ground | - | Driver seat belt buckle switch signal | Driver seat belt fastened | 10 kΩ or higher |
| MB-18 (DBKL) - Body ground | - | Driver seat belt buckle switch signal | Driver seat belt unfastened | Below 1 Ω |
| CHECK COMBINATION METER ASSEMBLY |
Disconnect the I18 combination meter assembly connector.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| I18-7 (ES) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the I18 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| I18-1 (B) - Body ground | W - Body ground | Battery power supply | Always | 11 to 14 V |
| I18-13 (IG+) - Body ground | L - Body ground | Ignition power supply (IG signal) | Ignition switch off | Below 1 V |
| I18-13 (IG+) - Body ground | L - Body ground | Ignition power supply (IG signal) | Ignition switch ON | 11 to 14 V |