Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for Separate Type Yaw Rate Sensor)

AIRBAG SYSTEM (for Separate Type Yaw Rate Sensor) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.

HINT:
  1. When multiple warning lights in the combination meter blink continuously, a ground short in the wiring or an ECU connected to terminal TC of the DLC3 is suspected.
  2. A DTC output mode signal is transmitted through the CAN communication system to each ECU including the airbag sensor assembly. Thus when multiple systems do not enter DTC output mode, there may be a ECM malfunction.


WIRING DIAGRAM


C249051E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)


    C238361E03
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 2GR-FE: 
    Tester Connection
    Condition
    Specified Condition
    I39-13 (TC) - A25-45 (TC)
    Always
    Below 1 Ω
    for 2AR-FE: 
    Tester Connection
    Condition
    Specified Condition
    I39-13 (TC) - A25-23 (TC)
    Always
    Below 1 Ω

    Text in Illustration 
    *A
    for 2GR-FE
    *B
    for 2AR-FE
    *1
    DLC3
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE WIRE HARNESS
OK


2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    C204945E20
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I39-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    DLC3



NG
REPAIR OR REPLACE WIRE HARNESS
OK


3.CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND)


    C204945E21
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I39-13 (TC) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *1
    DLC3



NG
REPAIR OR REPLACE WIRE HARNESS OR REPLACE ECM
OK

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)