Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Unlock Warning Switch Circuit

for Preparation Click here


DESCRIPTION

The key unlock warning switch assembly comes on when the ignition key is inserted into the ignition key cylinder and goes off when the ignition key is removed.

WIRING DIAGRAM


B163408E10


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch/ON or OFF
    ON: Key is inserted into ignition key cylinder
    OFF: Key is removed from ignition key cylinder
    -

    OK:
    When the key is in the ignition key cylinder, "ON" appears on the screen.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B289676E02
  1. Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Free
    (Key removed)
    10 kΩ or higher
    1 - 2
    Pushed
    (Key set)
    Below 1 Ω

    Text in Illustration 
    *1
    Free (key removed)
    *2
    Pushed (key set)
    *a
    Component without harness connected
    (Unlock Warning Switch Assembly)



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - UNLOCK WARNING SWITCH - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I13-17 (KSW) - I33-1
    Always
    Below 1 Ω
    I13-17 (KSW) - Body ground
    Always
    10 kΩ or higher
    I33-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)