DTC P0717 Turbine Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic) (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/neutral position switch (NSW, R and L) is OFF (c) Speed sensor (NT): less than 300 rpm |
|

| Terminal | Tool setting | Vehicle condition |
| NT+ - NT- | 5 V/DIV., 0.5ms./DIV. | Vehicle speed 20 km/h (12 mph) |

| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NT) |
![]() |
Disconnect the speed sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20 °C (68 °F) | 560 to 680 Ω |
| *a | Component without harness connected (Speed Sensor) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E83-125 (NT+) - E83-124 (NT-) | 20°C (68°F) | 560 to 680 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E83-125 (NT+) - Body ground | Always | 10 kΩ or higher |
| E83-124 (NT-) - Body ground | Always |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||