DTC P0798 Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0798 | The ECM checks for an open or short in the shift solenoid valve SL3 circuit while driving and shifting gears. (1-trip detection logic)
|
|

| 1.CHECK HARNESS AND CONNECTOR (SHIFT SOLENOID VALVE SL3 CIRCUIT) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E26-11 (SL3+) - E26-10 (SL3-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| E26-11 (SL3+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E26-10 (SL3-) - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM - WIRING HARNESS CONNECTOR) |
Disconnect the harness connector from the wiring harness connector.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| E26-11 (SL3+) - E8-19 (SL3+) | Always | Below 1 Ω |
| E26-10 (SL3-) - E8-18 (SL3-) | Always | Below 1 Ω |
| E26-11 (SL3+) or E8-19 (SL3+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E26-10 (SL3-) or E8-18 (SL3-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION WIRE (SL3) |
![]() |
Remove the wiring harness connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-16 (SL3+) - A-15 (SL3-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| A-16 (SL3+) - Body ground and other terminals | Always | 10 kΩ or higher |
| A-15 (SL3-) - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | ||
| ||
| 4.INSPECT SHIFT SOLENOID VALVE SL3 |
![]() |
Remove shift solenoid valve SL3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.
| *1 | Shift Solenoid Valve SL3 |
|
| ||||
| OK | ||
| ||