VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL MANUAL VALVE |
Coat the manual valve with ATF and install it to the transmission valve body assembly.
| 2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Coat the O-ring of the transmission wire with ATF.
![]() |
Confirm that the manual valve lever is positioned as shown in the illustration and install the transmission valve body assembly to the transaxle case sub-assembly with the 11 bolts.
| *a | Positioning Bolt |
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.
Install the valve body oil strainer assembly to the transmission valve body assembly with the 2 bolts.
| 4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Install the 2 magnets onto the automatic transaxle oil pan sub-assembly as shown in the illustration.
| *1 | Magnet |
Install a new gasket to the automatic transaxle oil pan sub-assembly.
![]() |
Install the automatic transaxle oil pan sub-assembly to the automatic transaxle assembly with the 17 bolts.
![]() |
Clean and degrease the bolt and the installation hole in the automatic transaxle assembly.
Apply adhesive to the bolt.
Install the bolt.
| 5. INSTALL TORQUE CONVERTER ASSEMBLY |
![]() |
Engage the splines of the input shaft and turbine runner.
![]() |
Engage the splines of the stator shaft and the stator while turning the torque converter assembly.
![]() |
Turn the torque converter assembly to insert the key of the oil pump drive gear into the groove of the torque converter assembly.
Clean the torque converter set bolt holes.
![]() |
Using a vernier caliper and straightedge, measure dimension A between the transaxle contact surface of the engine and the torque converter contact surface of the drive plate.
| *a | Engine Surface |
| *b | Drive Plate Surface |
![]() |
Using a vernier caliper and straightedge, measure dimension B shown in the illustration and check that dimension B is more than dimension A, which was measured in the previous step.
| 6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |