Home › Vehicle Exterior › HORN › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HORN RELAY


    E226254E01
  1. Remove the horn relay.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the horn relay.