Home › Engine / Hybrid System ยท 2GR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.



2. INSTALL FUEL PUMP
  1. Install the fuel pump spacer onto the fuel pump assembly with filter.



    A204256
  1. Install a new fuel pump filter seal onto the fuel pump assembly with filter.

  1. Apply a coat of gasoline to the fuel pump filter seal.



    A136240E01
  1. Engage the 5 claws on the fuel filter and install the fuel pump with the suction filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during the installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.

    HINT:
    Perform "Inspection After Repair" after replacing the fuel pump assembly (Click here).



3. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A259331
  1. Engage the 2 claws of the No. 1 fuel suction support.



4. INSTALL LOWER FUEL TANK CASE SUB-ASSEMBLY
  1. Connect the fuel pump harness connector to the fuel pump.

  1. Install the spring to the fuel suction plate shaft and install it to the lower fuel tank case sub-assembly.



    A218240E04
  1. Engage the 4 claws of the No. 1 fuel suction support and install the lower fuel tank case sub-assembly to the fuel suction plate with the fuel filter.
    Text in Illustration 
    *1
    Claw

  1. Install a new E-ring.

  1. Connect the fuel pump harness connectors to the fuel suction plate.



5. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A222004
  1. Slide the fuel sender gauge to fit the claw.

  1. Connect the connector of the fuel sender gauge assembly.



6. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)