FUEL PRESSURE REGULATOR > REMOVAL |
| 1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
| 2. REMOVE FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge connector.
![]() |
Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.
| 3. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY |
![]() |
Disconnect the fuel pump harness connectors from the fuel suction plate.
![]() |
Using needle nose pliers, remove the E-ring.
| *1 | E-ring |
![]() |
Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub-assembly from the fuel suction plate with the fuel filter.
| *1 | Tube |
Remove the spring from the fuel suction plate.
| 4. REMOVE NO. 1 FUEL SUCTION SUPPORT |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
| 5. REMOVE FUEL PUMP |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
| *1 | Fuel Filter |
| *2 | Suction Filter |
![]() |
Disconnect the fuel pump harness connector.
![]() |
Remove the fuel pump filter seal from the fuel pump. If the fuel pump filter seal still remains in the fuel filter element, remove it using a wire tip (φ1 mm) that is formed as shown in the illustration.
| *1 | Fuel Pump Filter Seal |
| *a | 5.0 mm (0.197 in.) |
![]() |
Remove the fuel pump spacer from the fuel pump.
| 6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly from the fuel filter.
![]() |
Remove the 2 O-rings from the fuel pressure regulator assembly.
| *1 | O-ring |