Home › Engine / Hybrid System ยท 1AZ-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge connector.



    A136022
  1. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.



3. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY


    A136231
  1. Disconnect the fuel pump harness connectors from the fuel suction plate sub-assembly.



    A136234E03
  1. Using needle nose pliers, remove the E-ring.
    Text in Illustration 
    *1
    E-ring



    A211200E02
  1. Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub-assembly from the fuel suction plate sub-assembly with the fuel filter.
    Text in Illustration 
    *1
    Tube

    NOTICE:
    Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube (Click here).

  1. Remove the spring from the fuel suction plate sub-assembly.



4. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A255954
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.



5. REMOVE FUEL PUMP


    A136239E03
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and remove the fuel pump from the fuel filter.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter
    *3
    Protective Tape

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A283925
  1. Disconnect the fuel pump harness connector from the fuel pump.



    A288170E01
  1. Remove the O-ring and fuel pump spacer from the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer
    *a
    5.0 mm (0.197 in.)

    NOTICE:
    Be careful not to damage the sealing surface.

    HINT:
    If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A136235
  1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly from the fuel filter.

    NOTICE:
    Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the fuel pressure regulator assembly and the fuel filter.



    A148186E11
  1. Remove the 2 O-rings from the fuel pressure regulator assembly.
    Text in Illustration 
    *1
    O-ring