FUEL PRESSURE PULSATION DAMPER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 6. REMOVE FUEL TUBE SUB-ASSEMBLY |
![]() |
| *1 | No. 2 Fuel Pipe Clamp |
| *2 | Retainer |
| *3 | Fuel Hose Clamp |
| *4 | Fuel Tube Connector |
| *a | Turn |
Remove the fuel tube from the fuel hose clamp.
Remove the No. 2 fuel pipe clamp.
Wipe off any dirt on the fuel tube connector.
Hold the fuel tube connector, and then install SST.
Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.
Insert SST into the fuel tube connector and hold it. Then push the fuel tube connector toward SST.
Mount the retainer of the fuel tube connector onto the chamfered part of SST.
![]() |
Slide SST and the fuel tube connector together toward the fuel tube until they make a "click" sound, and then disconnect the fuel tube.
| *1 | O-ring |
| *2 | Retainer |
| *3 | Fuel Tube |
| *4 | Fuel Tube Connector |
| *5 | Fuel Pipe |
| 7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Remove the 2 bolts and fuel pressure pulsation damper.
Remove the O-ring from the fuel pressure pulsation damper.