Home › Engine / Hybrid System · 2GR-FE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Specified Condition
    1 - 2
    6.9 to 7.9 Ω at 20°C (68°F)

    If the result is not as specified, replace the oil control valve assembly.



    A095391E08
  1. Check the operation.
    Text in Illustration 
    *1
    Spool Valve
    *2
    Battery

    1. Connect a battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the spool valve.

      OK:
      Condition
      Specified Condition
      Battery voltage is applied
      Valve moves in black arrow direction shown in illustration
      Battery voltage is not applied
      Valve moves in white arrow direction shown in illustration

      If the result is not as specified, replace the oil control valve.

      NOTICE:
      Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks in the intake side oil control valve will cause the intake camshaft to advance. Minor pressure leaks in the exhaust side oil control valve will cause the exhaust camshaft to retard. The inappropriate camshaft timing that results from these leaks will cause a DTC to be set.