Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > INSPECTION

for Preparation Click here




1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    6.9 to 7.9 Ω

    If the result is not as specified, replace the camshaft timing oil control valve assembly.



    A095391E14
  1. Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2, and check the movement of the valve.
    Text in Illustration 
    *1
    Valve
    *a
    Component without harness connected
    (Camshaft Timing Oil Control Valve Assembly)
    *b
    When applied
    *c
    When cut off

    OK:
    Condition
    Specified Condition
    Battery voltage is applied
    Valve moves in left arrow direction shown in illustration
    Battery voltage is cut off
    Valve moves in right arrow direction shown in illustration

    NOTICE:
    Confirm that the valve moves freely and does not stick in any position.

    If necessary, replace the camshaft timing oil control valve assembly.

    HINT:
    Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be set.