Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A255403
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. SEPARATE ENGINE WIRE


    A254782
  1. Remove the 2 nuts and separate the engine wire.



3. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


  1. Camshaft timing oil control valve assembly (for exhaust side)



      A254784
    1. Disconnect the oil control valve connector.

    2. Remove the bolt and oil control valve.



    3. A195062E06
    4. Remove the O-ring from the oil control valve.
      Text in Illustration 
      *1
      O-ring



  1. Camshaft timing oil control valve assembly (for intake side)



      A254785
    1. Disconnect the oil control valve connector.

    2. Remove the bolt and oil control valve.



    3. A195062E06
    4. Remove the O-ring from the oil control valve.
      Text in Illustration 
      *1
      O-ring