ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
Install a new gasket onto the engine coolant temperature sensor.
Install the engine coolant temperature sensor.
Connect the engine coolant temperature sensor connector.
Connect the 2 engine wire clamps.
| 2. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Close the cylinder block drain cock plug (for Bank 1).
Close the cylinder block drain cock plug (for Bank 2, w/ Cylinder Block Drain Cock Plug).
Loosen the air drain cock plug on the water inlet housing.
Add TOYOTA Super Long Life Coolant (SLLC) to the radiator inlet opening until engine coolant overflows from the air drain cock hole. Then tighten the air drain cock plug to the water inlet housing.
![]() |
Slowly fill the radiator assembly with TOYOTA Super Long Life Coolant (SLLC).
| *a | Code Mark |
| Code Mark "K" | 8.8 liters (9.3 US qts, 7.7 lmp. qts) |
| Code Mark "J" | 8.9 liters (9.4 US qts, 7.8 lmp. qts) |
Remove the reserve tank cap.
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 3. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf*cm, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
| 4. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.
| 5. INSTALL V-BANK COVER SUB-ASSEMBLY |
Fit the 3 retainers and install the V-bank cover sub-assembly.
| 6. INSTALL ENGINE UNDER COVER RH |
| 7. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH |
| 8. INSTALL ENGINE UNDER COVER LH |
| 9. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH |