Home › Engine / Hybrid System · 2GR-FE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A183498E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E2) - 2 (THW)
    20°C (68°F)
    2.32 to 2.59 kΩ
    1 (E2) - 2 (THW)
    80°C (176°F)
    0.310 to 0.326 kΩ

    NOTICE:
    If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.

    If the result is not as specified, replace the engine coolant temperature sensor.