Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A214444E05


Text in Illustration 
*a
Component without harness connected
(Engine Coolant Temperature Sensor)
*b
Temperature °C (°F)
*c
Resistance kΩ
*d
Acceptable
  1. Partially immerse the engine coolant temperature sensor in water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    1 - 2
    80°C (176°F)
    0.310 to 0.326 kΩ

    NOTICE:
    When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.

    If the result is not as specified, replace the engine coolant temperature sensor.