Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


3. REMOVE ENGINE UNDER COVER LH


4. REMOVE ENGINE UNDER COVER RH


5. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the radiator cap sub-assembly.


    A255283E01


    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A255403
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



7. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



8. REMOVE INLET AIR CLEANER ASSEMBLY


    A255404
  1. Remove the 2 bolts and inlet air cleaner assembly.



9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A254801
  1. Disconnect the engine coolant temperature sensor connector.



    A254800
  1. Remove the 2 bolts and disconnect the wire harness.



    A255139E01
  1. Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
    Text in Illustration 
    *1
    Ball Joint Lock Nut Wrench
    *2
    Gasket

  1. Remove the gasket from the engine coolant temperature sensor.