Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
  1. Check that the throttle valve opens and closes smoothly.

  1. Check that there is no foreign matter accumulated around the throttle with motor body assembly.



    A062403E11
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-1 (M-) - E16-2 (M+)
    20°C (68°F)
    0.3 to 100 Ω

    If the result is not as specified, replace the throttle with motor body assembly.