Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK THROTTLE WITH MOTOR BODY ASSEMBLY
  1. Check the throttle control motor operating sound.

    1. Turn the ignition switch to ON.

    2. When depressing the accelerator pedal, check the operating sound of the throttle control motor. Make sure that no friction noises are emitted from the throttle control motor.
      If friction noises exist, replace the throttle with motor body assembly.

  1. Check the throttle position sensor.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Gas Throttle / Throttle Sensor Position.

    5. Depress the accelerator pedal. While the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is within the specification.

      Standard throttle valve opening percentage:
      60% or more

      NOTICE:
      When checking the standard throttle valve opening percentage, make sure that the shift lever is in N.

      If the percentage is less than 60%, replace the throttle with motor body assembly.