Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK CONTROL SENSOR


    A129616E04
  1. Install the 2 knock control sensors with the 2 bolts as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    for Bank 1
    *b
    for Bank 2
    *c
    Front of Vehicle

    NOTICE:
    Make sure that each knock control sensor is in the correct position.

  1. Connect the 2 knock control sensor connectors.



2. INSTALL INTAKE MANIFOLD
(Click here).