ECM > INSTALLATION |
| 1. INSTALL NO. 1 ECM BRACKET |
Install the no. 1 ECM bracket with the nut.
Connect the 2 wire harness clamps.
Install the nut.
| 2. INSTALL ECM |
Install the no. 2 ECM brackets to the ECM with the 2 screws.
Temporarily install the screw (B).
![]() |
Install the ECM with the nut.
Install the screw (A).
Tighten the screw (B).
Connect the 2 ECM connectors and lower the 2 levers.
| 3. INSTALL BATTERY |
Install the battery and battery tray.
Install the battery clamp with the bolt and nut.
Connect the positive (+) cable to the positive (+) battery terminal.
| 4. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. PERFORM INITIALIZATION |