Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR
  1. Clean and degrease the threads of the bolt for the camshaft position sensor.



    A095434E12
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
    Text in Illustration 
    *1
    O-ring

    NOTICE:
    Make sure that the O-ring is not cracked or moved out of place during installation.

  1. Install the camshaft position sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the camshaft position sensor connector.



2. CONNECT VENTILATION HOSE
  1. Connect the ventilation hose to the cylinder head cover sub-assembly.



3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element to the air cleaner case sub-assembly.



    A265342E01
  1. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly and release the lock of the air cleaner hose clamp.
    Text in Illustration 
    *1
    Air Cleaner Hose Clamp

    NOTICE:
    1. Align the groove of the air cleaner cap sub-assembly with the tab of the throttle with motor body assembly and install the hose.
    2. Make sure that the tab of the air cleaner hose clamp stays within the range shown by *a.

  1. Connect the ventilation hose to the cylinder head cover.

  1. Install the air cleaner cap sub-assembly and tighten the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the wire harness clamp.

  1. Connect the mass air flow meter connector.

  1. Connect the purge line hose to the 2 clamps.

  1. Connect the 2 vacuum switching valve vacuum hoses.

  1. Connect the vacuum switching valve connector.



4. INSPECT FOR OIL LEAK


5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Install the No. 1 engine cover sub-assembly with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }