CAMSHAFT POSITION SENSOR > REMOVAL |
| 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 2. REMOVE CAMSHAFT POSITION SENSOR |
Camshaft position sensor (for Exhaust Side)
![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.
Camshaft position sensor (for Intake Side)
![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.