Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Remove the 2 nuts and No. 1 engine cover sub-assembly.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A264433
  1. Disconnect the vacuum switching valve connector.

  1. Disconnect the 2 vacuum switching valve vacuum hoses.

  1. Disconnect the purge line hose from the 2 clamps.

  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Loosen the 2 bolts and separate the air cleaner cap sub-assembly.



    A264435
  1. Disconnect the ventilation hose from the cylinder head cover sub-assembly.



    A264436E01
  1. Lock the air cleaner hose clamp as shown in the illustration, and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.
    Text in Illustration 
    *1
    Air Cleaner Hose Clamp

  1. Remove the air cleaner filter element from the air cleaner case sub-assembly.



3. DISCONNECT VENTILATION HOSE


    A264435
  1. Disconnect the ventilation hose from the cylinder head cover sub-assembly.



4. REMOVE CAMSHAFT POSITION SENSOR


    A264426
  1. Disconnect the camshaft position sensor connector.

  1. Remove the bolt and camshaft position sensor.