Home › Power Source / Network · 2AR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR PULLEY WITH CLUTCH


    A208964E03
  1. Hold the generator rotor using SST, and turn the generator pulley with clutch clockwise to check that the outer ring locks.

    SST
    09820-63021  
    Text in Illustration 
    *a
    Free
    *b
    Lock
    If the result is not as specified, replace the generator pulley with clutch.



2. INSPECT GENERATOR DRIVE END FRAME BEARING


    A192785
  1. Check that the bearing is not rough or worn and that it rotates smoothly.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.



3. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A128079E12
  1. Using a vernier caliper, measure the brush length.
    Text in Illustration 
    *a
    Length

    Standard length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.



4. INSPECT GENERATOR ROTOR ASSEMBLY


    A192784
  1. Check that the generator rotor bearing is not rough or worn.
    If the result is not as specified, replace the generator rotor assembly.



    A097476E12
  1. Check the rotor for an open circuit.
    Text in Illustration 
    *1
    Slip Ring
    *2
    Ohmmeter

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      Approx. 20°C (68°F)
      2.3 to 2.7 Ω

      If the result is not as specified, replace the generator rotor assembly.



    A097477E06
  1. Check if the rotor is grounded.
    Text in Illustration 
    *1
    Slip Ring
    *2
    Ohmmeter
    *3
    Rotor

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor
      Always
      10 kΩ or higher

      If the result is not as specified, replace the generator rotor assembly.



  1. Check the slip ring diameter.



      A097470E07
    1. Using a vernier caliper, measure the diameter of each slip ring.
      Text in Illustration 
      *a
      Diameter

      Standard diameter:
      14.2 to 14.4 mm (0.559 to 0.567 in.)

      Minimum diameter:
      14 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.