Home › Power Source / Network ยท 2AR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY CAP


    A194719
  1. Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.



2. REMOVE GENERATOR PULLEY WITH CLUTCH


    A197237E02
  1. Mount the generator in a vise.
    Text in Illustration 
    *1
    SST (A)
    *2
    SST (B)

  1. Install SST (A) and (B) to the pulley as shown in the illustration.

    SST
    09820-63021  



    A197239E02
  1. Use a wrench to hold SST (A), and turn SST (B) counterclockwise to loosen the generator pulley.
    Text in Illustration 
    *1
    SST (A)
    *2
    SST (B)

    NOTICE:
    1. Check that the drive end frame is secured in the vise tightly.
    2. Hold SST (A) tightly during the operation.

  1. Remove the generator pulley.



3. REMOVE GENERATOR REAR END COVER
  1. Place the generator on the generator pulley.



    A192779
  1. Remove the 3 nuts and generator rear end cover.



    A192780
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A192781
  1. Remove the 2 screws and generator brush holder.



5. REMOVE GENERATOR COIL ASSEMBLY


    A192782
  1. Remove the 4 bolts.



    A192783E01
  1. Using SST, remove the generator coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A118365E01
  1. Remove the generator washer.



    A118367E01
  1. Remove the generator rotor assembly.



7. INSPECT GENERATOR DRIVE END FRAME BEARING


    A192785
  1. Check that the bearing is not rough or worn and that it rotates smoothly.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A192787
  1. Remove the 4 screws and bearing retainer.



    A192788E01
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)