Home › Engine / Hybrid System ยท 1AZ-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

  1. Loosen the cylinder block drain cock plug.



  1. Remove the radiator cap sub-assembly.


    A264832E01


    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Cylinder Block Drain Cock Plug
    -

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.



2. REMOVE V-RIBBED BELT
(Click here)


3. REMOVE GENERATOR ASSEMBLY
(Click here)


4. REMOVE WATER PUMP PULLEY


    A098715E03
  1. Using SST, remove the 4 bolts and water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)



5. REMOVE ENGINE WATER PUMP ASSEMBLY


    A129794E02
  1. Disconnect the connector of the crankshaft position sensor.
    Text in Illustration 
    *1
    Wire Harness Clamp Bracket

  1. Disconnect the wire of the crankshaft position sensor from the wire harness clamp brackets.



    A129795E03
  1. Remove the 4 bolts, 2 nuts and 2 wire harness clamp brackets.
    Text in Illustration 
    *1
    Wire Harness Clamp Bracket



    A129796
  1. Using a screwdriver, pry between the engine water pump assembly and cylinder block, and then remove the engine water pump assembly.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the contact surfaces of the engine water pump assembly and cylinder block.