Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT

for Preparation Click here



1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Remove the transmission control shaft lever .



    C132993
  1. Loosen the bolts of the park/neutral position switch assembly.



    Z035571E02
  1. Align the nut stopper protrusion with the neutral basic line.
    Text in Illustration 
    *a
    Nut Stopper Protrusion
    *b
    Neutral Basic Line

  1. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    After installing the park/neutral position switch assembly, confirm that the nut stopper protrusion and neutral basic line on the switch are aligned.

  1. Install the transmission control shaft lever .

  1. After the adjustment, perform the switch operation check (Click here).