Home › Drivetrain · U241E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C196095E05
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Park/Neutral Position Switch Assembly)

    Standard Resistance:
    Tester Connection
    Shift Position
    Specified Condition
    4 (B) - 5 (L)
    P and N
    Below 1 Ω
    Except P and N
    10 kΩ or higher
    2 (RB) - 6 (PL)
    P
    Below 1 Ω
    Except P
    10 kΩ or higher
    2 (RB) - 1 (RL)
    R
    Below 1 Ω
    Except R
    10 kΩ or higher
    2 (RB) - 9 (NL)
    N
    Below 1 Ω
    Except N
    10 kΩ or higher
    2 (RB) - 7 (DL)
    D, S, "+" and "-"
    Below 1 Ω
    Except D, S, "+" and "-"
    10 kΩ or higher

    If the resistance value is not as specified, replace the park/neutral position switch assembly.