Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Remove the 2 nuts and No. 1 engine cover sub-assembly.



4. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



5. REMOVE INLET AIR CLEANER ASSEMBLY


    A264362
  1. Remove the 2 bolts and inlet air cleaner assembly.



6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A264433
  1. Disconnect the vacuum switching valve connector.

  1. Disconnect the 2 vacuum switching valve vacuum hoses.

  1. Disconnect the purge line hose from the 2 clamps.

  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Loosen the 2 bolts and separate the air cleaner cap sub-assembly.



    A264435
  1. Disconnect the ventilation hose from the cylinder head cover sub-assembly.



    A264436E01
  1. Lock the air cleaner hose clamp as shown in the illustration, and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.
    Text in Illustration 
    *1
    Air Cleaner Hose Clamp

  1. Remove the air cleaner filter element from the air cleaner case sub-assembly.



7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A264522
  1. Disconnect the wire harness clamp.

  1. Remove the 3 bolts and air cleaner case sub-assembly.



8. REMOVE BATTERY
  1. Loosen the nut, and disconnect the cable from the positive (+) battery terminal.



    C248643
  1. Loosen the nut, and remove the bolt and battery clamp.

  1. Remove the battery from the battery tray.



9. REMOVE BATTERY TRAY
  1. Remove the battery tray from the body.



10. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Move the shift lever to N.



    C132989E01
  1. Disconnect the connector from the park/neutral position switch assembly.



    C248647
  1. Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

  1. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.



    C132991
  1. Remove the nut, washer and control shaft lever from the manual valve lever shaft sub-assembly.



    C132992
  1. Pry out the lock plate and remove the nut and lock plate from the manual valve lever shaft sub-assembly.



    C132993
  1. Remove the 2 bolts and pull out the park/neutral position switch assembly from the manual valve lever shaft sub-assembly.