LUGGAGE DOOR HINGE TORSION BAR > INSTALLATION |
| 1. INSTALL LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT |
![]() |
Install a new luggage compartment door torsion bar support as shown in the illustration.
| 2. INSTALL LUGGAGE DOOR HINGE TORSION BAR RH |
Check the identification mark on the luggage door hinge torsion bar RH.
![]() |
Set the tip of the luggage door hinge torsion bar RH in the center installation hole. The upper and lower installation holes are used for adjustment.
| *a | Installation Hole |
| *b | Installation Hole (For Adjustment) |
![]() |
Connect the luggage door hinge torsion bar RH to the left side of the vehicle body as shown in the illustration.
![]() |
Connect the luggage door hinge torsion bar RH to the luggage compartment door torsion bar support as shown in the illustration.
![]() |
Using SST, install the luggage door hinge torsion bar RH to the luggage door hinge and the right side of the vehicle body as shown in the illustration.
Remove the protective tape.
| 3. INSTALL LUGGAGE DOOR HINGE TORSION BAR LH |
Check the identification mark on the luggage door hinge torsion bar RH.
![]() |
Set the tip of the luggage door hinge torsion bar LH in the center installation hole. The upper and lower installation holes are used for adjustment.
| *a | Installation Hole |
| *b | Installation Hole (For Adjustment) |
![]() |
Connect the luggage door hinge torsion bar LH to the right side of the vehicle body as shown in the illustration.
![]() |
Connect the luggage door hinge torsion bar LH to the luggage compartment door torsion bar support as shown in the illustration.
![]() |
Using SST, install the luggage door hinge torsion bar LH to the luggage door hinge and the left side of the vehicle body as shown in the illustration.
![]() |
Engage the 2 claws as shown in the illustration.
for Fold Down Seat Type:
![]() |
Connect the rear seatback lock assembly LH (rear seat lock control cable LH) and engage the hook in the order indicated in the illustration.
Engage the clamp.
Remove the protective tape.
| 4. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH |
Engage the 4 claws and install the luggage compartment door hinge cover LH.
| 5. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH |
| 6. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH |
Install the 3 clips.
Engage the fastener and install the luggage compartment inner trim cover LH.
| 7. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH |
Install the 3 clips.
Engage the fastener and install the luggage compartment inner trim cover RH.
| 8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
![]() |
Engage the 2 pins to install the 2 No. 1 luggage compartment trim hooks.
| *1 | Pin |
| 9. INSTALL REAR FLOOR FINISH PLATE |
![]() |
Engage the 4 clips and install the rear floor finish plate.
Install the 5 clips.
| 10. INSTALL BAGGAGE HOLDER NET (w/ Partition Net) |
Install the baggage holder net.
| 11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT |
Install the luggage compartment floor mat.