Home › Engine / Hybrid System ยท 2AR-FE › INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


3. REMOVE ENGINE UNDER COVER LH


4. REMOVE ENGINE UNDER COVER RH


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A254718
  1. Disconnect the heated oxygen sensor connector.



    A254747
  1. Remove the 2 bolts, 2 compression springs and 2 nuts.

  1. Remove the front exhaust pipe assembly from the exhaust pipe support.

  1. Remove the 2 gaskets from the exhaust manifold converter sub-assembly and front exhaust pipe assembly.



6. REMOVE MANIFOLD STAY


    A195975
  1. Remove the bolt, nut and manifold stay.



7. REMOVE NO. 2 MANIFOLD STAY


    A209598
  1. Remove the bolt, nut and No. 2 manifold stay.



8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A209579
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator.



9. REMOVE AIR FUEL RATIO SENSOR
(Click here)


10. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    A195979
  1. Remove the 5 nuts and exhaust manifold converter sub-assembly.



    A195981E01
  1. Remove the exhaust manifold to head gasket.



11. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A211654
  1. Remove the 2 bolts and No. 2 exhaust manifold heat insulator.



12. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR


    A211653
  1. Remove the 4 bolts and No. 1 manifold converter insulator.