Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT NO. 1 INTEGRATION RELAY



A284530E01


Text in Illustration 
*1
No. 1 Integration Relay
-
-


  1. EFI MAIN relay:



      A255141E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      Component without harness connected
      (No. 1 Integration Relay)

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      1B-1 - 1A-8
      Battery voltage not applied between terminals 1C-7 and 1E-2
      10 kΩ or higher
      1B-1 - 1A-8
      Battery voltage applied between terminals 1C-7 and 1E-2
      Below 1 Ω
      1B-1 - 1C-3
      1B-1 - 1C-4
      1B-1 - 1C-9
      1B-1 - 1C-10

      If the resistance is not as specified, replace the No. 1 integration relay.



  1. IG2 relay:



      A255141E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      Component without harness connected
      (No. 1 Integration Relay)

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      1A-1 - 1D-3
      Battery voltage not applied between terminals 1C-8 and 1E-2
      10 kΩ or higher
      1A-1 - 1D-3
      Battery voltage applied between terminals 1C-8 and 1E-2
      Below 1 Ω
      1A-3 - 1D-3
      1C-1 - 1D-3
      1C-2 - 1D-3
      1C-5 - 1D-3

      If the resistance is not as specified, replace the No. 1 integration relay.



  1. C/OPN relay:



      A255141E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *1
      Component without harness connected
      (No. 1 Integration Relay)

      Standard Resistance:

      Tester Connection
      Condition
      Specified Condition
      1A-7 - 1C-6
      Battery voltage not applied between terminals 1A-1 and 1E-1
      10 kΩ or higher
      1A-7 - 1C-6
      Battery voltage applied between terminals 1A-1 and 1E-1
      Below 1 Ω
      1A-6 - 1C-6

      If the resistance is not as specified, replace the No. 1 integration relay.