REAR BRAKE > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. DRAIN BRAKE FLUID |
| 3. SEPARATE REAR FLEXIBLE HOSE |
![]() |
Remove the union bolt and gasket, and separate the rear flexible hose from the rear disc brake cylinder assembly.
| 4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Hold the rear disc brake cylinder slide pin, and remove the 2 bolts and rear disc brake cylinder assembly.
| *a | Hold |
| *b | Turn |
| 5. REMOVE REAR DISC BRAKE PAD |
![]() |
Remove the 2 rear disc brake pads with rear disc brake anti-squeal shim kit from the disc brake cylinder mounting.
| 6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
![]() |
Remove the rear disc brake anti-squeal shim from each rear disc brake pad.
![]() |
Remove the rear disc brake pad wear indicator plate from each rear disc brake pad.
| 7. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE |
![]() |
Remove the 2 rear disc brake pad support plates from the disc brake cylinder mounting.
| 8. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN (for Upper Side) |
![]() |
Remove the rear disc brake cylinder slide pin from the disc brake cylinder mounting.
| 9. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN (for Lower Side) |
![]() |
Remove the rear disc brake cylinder slide pin from the disc brake cylinder mounting.
| 10. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSHING |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the rear disc brake cylinder slide bushing from the rear disc brake cylinder slide pin.
| *1 | Vinyl Tape |
| 11. REMOVE REAR DISC BRAKE BUSHING DUST BOOT |
![]() |
Remove the 2 rear disc brake bushing dust boots from the disc brake cylinder mounting.
| 12. REMOVE DISC BRAKE CYLINDER MOUNTING |
![]() |
Remove the 2 bolts and disc brake cylinder mounting.
| 13. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the parking brake shoe adjusting hole plug.
| 14. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the rear axle hub.
| *a | Matchmark |
![]() |
Release the parking brake and remove the rear disc.