Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    B279114E01
  1. Disengage the claw.
    Text in Illustration 
    *1
    Guide
    *2
    Pin

  1. Disengage the guide and pin, and remove the map light bracket.



    B279115
  1. Remove the 2 bolts and sliding roof drive gear sub-assembly.



2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    B279116
  1. Remove the screw and the sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side.



    B286382
  1. Slide and remove the sunshade trim sub-assembly.



3. REMOVE REAR SLIDING ROOF PANEL


    B286383E01
  1. Using a screwdriver, disengage the 2 claws. Then slide the rear sliding roof panel rearward to remove it.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.



    B279124
  1. Hold down the roof wind deflector panel sub-assembly.



    B279121E01
  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the other sliding roof drive cable sub-assembly.



5. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    B279125E01
  1. Pull the spring in the direction indicated by the arrow (1) in the illustration to disengage the 2 springs.
    Text in Illustration 
    *1
    Spring
    *2
    Guide

  1. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove it.