SLIDING ROOF HOUSING > REASSEMBLY |
| 1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY |
![]() |
Engage the 2 guides in the direction indicated by the arrow (1) in the illustration to install the roof wind deflector panel sub-assembly.
| *1 | Guide |
| *2 | Spring |
Engage the 2 springs in the direction indicated by the arrow (2) in the illustration.
| 2. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
![]() |
Hold down the roof wind deflector panel sub-assembly.
![]() |
Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.
| *1 | Protective Tape |
| 3. INSTALL REAR SLIDING ROOF PANEL |
![]() |
Insert the rear sliding roof panel in the direction indicated by the arrow (1) in the illustration.
Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear sliding roof panel.
| 4. ADJUST FULLY CLOSED POSITION |
![]() |
Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and alignment marks.
| *1 | Alignment Mark |
| 5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY |
![]() |
Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.
![]() |
Install the sliding roof piece sub-assembly LH with the screw.
| 6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
![]() |
Install the sliding roof drive gear sub-assembly with the 2 bolts.
![]() |
Engage the guide and pin.
| *1 | Guide |
| *2 | Pin |
Engage the claw and install the map light bracket.