SLIDING ROOF HOUSING > REMOVAL |
| 1. REMOVE ROOF HEADLINING ASSEMBLY |
| 2. REMOVE SLIDING ROOF SIDE GARNISH LH |
![]() |
Disengage the 2 claws and remove the sliding roof side garnish LH.
| 3. REMOVE SLIDING ROOF SIDE GARNISH RH |
| 4. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY |
![]() |
Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.
| 5. REMOVE SLIDING ROOF PANEL OR REMOVABLE ROOF WEATHERSTRIP |
Remove the sliding roof panel or removable roof weatherstrip from the sliding roof panel assembly.
| 6. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
![]() |
Using a clip remover, remove the pin.
Using 2 screw drivers, disengage the 2 claws and remove the clip from the body panel as shown in the illustration.

| *1 | Body Panel | *2 | Curtain Shield Airbag Assembly |
While holding the curtain shield airbag assembly, disengage the 5 claws.

Remove the 2 bolts.

Disengage the 2 hooks to remove the curtain shield airbag assembly.
Remove the 2 spacers from the curtain shield airbag assembly.
| 7. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH |
| 8. REMOVE REAR NO. 2 SIDE RAIL SPACER LH |
![]() |
Disengage the 2 claws and remove the rear No. 2 side rail spacer LH.
| 9. REMOVE REAR NO. 2 SIDE RAIL SPACER RH |
| 10. REMOVE SLIDING ROOF HOUSING ASSEMBLY |
![]() |
for Clamp Type:
Disengage the claw and disconnect the sliding roof drain hose.
![]() |
for Clip Type:
Expand the clip and disconnect the sliding roof drain hose.
Remove the 4 bolts, 8 nuts and sliding roof housing assembly.
